Precautions for maintenance and cleaning of complete rice pr

1. In the production of complete sets of rice processing equipment, the comprehensive management of equipment operation should be strengthened. During the use of the motor, the responsibility system is strictly implemented. The maintenance personnel conduct regular and quantitative inspections on each shift, observe and monitor the motors, and deal with problems in time.

 

2. In order to ensure the complete operation of the rice processing equipment control system, the electrical components in the secondary line of the control motor must be regularly inspected and maintained to ensure that they are in good condition. The over-current and short-circuit protection devices must be regularly verified to ensure reliable action Sensitive, so that the motor is always in good running condition.

 

3. In addition to daily inspections and maintenance, rice processing equipment and other mechanical equipment usually require annual overhaul. During the annual overhaul, the motor must be disassembled and maintained, bearing cleaning and refueling or replacement, insulation monitoring, and cooling system perfected to ensure that the motor Run in an intact state.

 

    Pay attention to when cleaning the complete set of rice processing equipment: When disassembling the complete set of processing equipment, use suitable tools instead of violently knocking to avoid damage or deformation of parts. The dirt and oil on the surface should be removed before disassembly, and it should be kept clean during disassembly. After the parts are disassembled, they should be sorted and stored according to the nature of the material and the fineness of the parts. Disassemble according to the needs of processing complete sets of equipment, and disassemble as little as possible, and do not disassemble if disassembly is not allowed. When disassembling a complete set of processing equipment, prepare for the assembly. In order to improve the assembly efficiency and ensure the correctness of the assembly, the disassembly should be checked and marked. To disassemble the complete set of processing equipment in a reasonable order, generally from accessories to main parts, from outside to inside, first disassemble the whole machine into an assembly, then from the assembly into parts, and from parts into parts.